Insignia IS-TV040922 - Manual (Page 13)

TV/CATV selection
Setting the channels into memory
Tuning in
Before your TV can memorize the available channels, you must
specify the type of signal source that is connected to the unit.
(i.e., an antenna or cable system)
1
2
Press CH- or CH+ to select
Signal Input.
Select Air if using VHF/UHF antenna, select CATV if using
Cable TV.
Select one of CATV(STD)/CATV(HRC)/CATV(IRC) according
to your local area’s cable system if using Cable TV.
This TV is equipped with a channel memory feature which
allows channels to skip up or down to the next channel set into
memory, skipping over unwanted channels. Before selecting
channels, they must be programmed into the TV’s memory.
Search
Signal Input
Channel
Skip
Auto Search
Fine tune
12
Menu control buttons
DSP
Press MENU repeatedly to display Search menu.
3
Press V- or V+ to select Air or
CATV(STD) or CATV(HRC) or
CATV(IRC).
1
2
Press CH- or CH+ to select Auto
Search.
Press MENU repeatedly to
display Search
menu.
3
Press V+ to start the search.
The TV will begin memorizing all
the channels available in your
area.
4
Press DSP button to clear the
menu screen.
Air
28
Off
Press V+
0
Search
Signal Input
Channel
Skip
Auto Search
Fine tune
Air
12
Off
Press V+
0
Search
Signal Input
Channel
Skip
Auto Search
Fine tune
Air
12
Off
Busy
0
TV/AV
CCD
DSP
MUTE
1 2 3
4 5 6
7 8 9
0
SCAN P
CH+
MENU
CH-
V- V+
STEREO
4
Press DSP button to clear the menu screen.