Sleep operation nap operation, Snooze/dimmer operation – iHome IP21 User Manual
Page 10
1. When the iP21 is off or while listening to your iPhone/iPod, press the Sleep Button to enter sleep mode. The Sleep Icon
will appear on the display to indicate it is in sleep mode. Sleep mode has a Gentle Sleep feature which gradually lowers
the volume before it shuts off.
2. You can adjust the sleep timer from 90, 60, 30 or 15 minutes by pressing the Sleep Button again. The unit will automati-
cally turn off after the selected time.
3. When the display changes back to show the real time, pressing the Sleep Button once will show the sleep time remain-
ing. Pressing it again will change the sleep time to the next lowest increment.
4. The iP21 has an independent volume setting for sleep mode so you can adjust the sleeping volume without affecting the
alarm volume. Press the and Button on the iP21 to adjust the sleep volume. The sleep volume will remain at
that level the next time you enter sleep mode until controls are changed.
5. To stop listening at any time, press the Button on the iP21 to turn it off.
7
Sleep Operation
Nap Operation
1. Press
the
Snooze/Dimmer Button on the iP21 after the alarm sounds. The alarm will go off and will come on again in
approx. 9 minutes. You may repeat this cycle several times during the one hour alarm cycle.
2. During
normal
operation,
press
the
Snooze/Dimmer Button to control the brightness (high, medium, low and off) of the
LCD display.
Snooze/Dimmer Operation
1. Press
the
Nap Button on the top left of the iP21 as needed to set a nap time of 15, 30, 60 or 90 minutes. The alarm will
come on after the set duration. If no iPhone or iPod is detected a buzzer alarm will sound. Press the Nap Button during
the nap cycle to view the nap time remaining. Press again to change to the next highest nap time setting.
2. When Nap timer comes on, the Sleep/Nap icon will flash and unit will play iPhone or Pod (buzzer if no player detected).
3. Press
the
Button to turn the nap alarm mode off.
Note: Sleep and Nap modes are independent; you can not run both at the same time.