Assembly – Ironman Fitness 220t User Manual

Page 7

Assembly

Figure 3: Left and Right Upright Installation

Figure 4: Console Installation

4. Install the Left and Right Uprights to the tread-
mill base frame by inserting the upright connect-
ing bracket into base frame as seen in Figure 3,
using Allen Bolt 5/16”-18 x 70 (Qty. 4), Spring
Washer 8 mm (Qty. 4), and Washer 9*16*1.6 mm
(Qty. 4).
Next, install the Allen Bolt 5/16”-18 x 15 (Qty.
6), Spring Washer 8 mm (Qty. 6), and Washer
9*16*1.6 mm (Qty. 6). Refer to Figure 3.

Note: Do not tighten hardware in step 3 until step
5 is completed.

IMPORTANT, PLEASE NOTE:
While sliding the upright connecting bracket into
the base frame, make sure the harness is
installed inside the upright and pay attention
not to pinch the wire harness.

5. Connect the Console Harness together as shown
in Figure 4. Wiring harness connectors snap
together as shown in Figure 2.

Note: The upright console harness wire must be
inserted through large hole at front side of
upright, before connecting to harness from
console assembly.

Connect the Console to the Left and
Right Uprights by sliding the Console
connecting brackets into the end of the Left and
Right Uprights as shown in Figure 4. Tighten into
place using 5/16”-18x45 Shoulder Allen Bolt (Qty.
2), Spring Washer 8 mm (Qty. 2), and Washer
9*16*1.6 mm (Qty. 2).

IMPORTANT, PLEASE NOTE:
While connecting the Console to the Left and
Right Uprights, pay attention not to pinch the wire
harness.

LEFT UPRIGHT

RIGHT UPRIGHT

SPRING WASHER 8 mm

CONSOLE
HARNESS

WASHER 9*16*1.6 mm

ALLEN BOLT
5/16”- 18x70

ALLEN BOLT
5/16”-18x15

CONSOLE

EKG HARNESS

SHOULDER ALLEN
BOLT 5/16”-18x45