IMC Networks Management Module SNMP User Manual
Page 11

8
Saved Values
This section displays changes made during current session:
• IP Address (MUST be assigned during initial configuration)
• Subnet Mask (MUST be assigned during initial configuration)
• Default Gateway
Current Values
This section displays values currently in use:
• IP Address (IP address of SNMP agent)
• Subnet Mask (mask to define IP subnet agent is connected to)
• Default Gateway (default router for IP traffic outside subnet)
Command List
This section displays the commands available:
• I = Enter New Saved Parameter Values
• P = Change Password
• T = New Trap Destination
• K = Remove ALL Trap Destinations
• C = New Community String
• U = Delete ALL Community Strings
• D = Enable/Disable DHCP
• E = End Session
• Space Bar = Device Specific Configuration commands
NOTE
Reboot after making any modifications to the saved parameter values or the changes
will not take effect. To reboot, type REBOOT at the prompt on the main configuration
screen, or turn the chassis OFF then ON again by turning off the switches on the back of
the power supplies, or reseat the module.
Assigning TCP/IP Information
To modify the saved parameter values (i.e., assign IP address and subnet
mask), press I. Enter the IP address and subnet mask for the connected