Removing – Invacare Adjustable ASBA Seat User Manual
Page 41
SECTION 7—POWER ELEVATING LEGRESTS
41
FIGURE 7.9 Removing/Installing the Power Elevating Legrest Harness
Removing/Installing the Power Elevating Legrest
Actuator
NOTE: For this procedure, refer to FIGURE 7.10 on page 42.
Removing
1. Remove the power elevating legrest from the wheelchair. Refer to Installing/
Removing the Power Elevating Legrests on page 34.
2. Disconnect the actuator connector (not shown) from the TRECM or DLIAM connector
(not shown).
3. Remove the long shoulder screw, flat washer, washer and locknut securing the top of
the power elevating legrest actuator to the power legrest bracket.
Power Elevating Legrest Connector
(To Legrest)
Cap Screws
Locknuts
T-Nut
Tie-Wrap
Front Harness Wire Bracket
Washer
Hex Screw
2-pin Anderson
Connector (To TRECM
or DLIAM)
Hex Screw
Washer
Rear Harness Wire Bracket
Rear Arm Socket
T-nut
Seat Frame
NOTE: T‐nuts shown
exploded away from
seat frame for clarity.
DETAIL “A” - TIE-WRAP
Tie-wrap
Harness
Harness
Rear Harness
Wire Bracket
DETAIL “B”
Jumper
Cable
Power
Legrest
Connector