Icom IC-718 - Manual (Page 14)

12
3
INSTALLATION AND CONNECTIONS
n Power supply connections
Use an optional PS-85 DC POWER SUPPLY w hen
operating the IC-718 with AC power. Refer to the
diagrams below.
CAUTION:
Before connecting the DC power
cable, check the following important items. Make
sure:
• The [POWER] switch is OFF.
• Output voltage of the power source is 12–15 V
when you use a non-Icom power supply.
• DC power cable polarity is correct.
Red : positive + terminal
Black : negative _ terminal
CONNECTING A VEHICLE BATTERY
12 V
battery
Supplied
DC power cable
+ red
_ black
Crimp
Solder
Grommet
Fuses
NOTE: Use terminals for
the cable connections.
CONNECTING NON-ICOM DC POWER SUPPLY
1 2 3 4 8 7 6 5 9 10 11 12 13
1 2 3 4 8 7 6 5 9 10 11 12 13
PS-85
Connect to an AC outlet
using the supplied AC cable.
DC power cable
DC power
socket
DC power
socket
DC power supply AC outlet
AC cable
20 A fuses
Supplied
DC power cable
13.8 V 20 A
_ +
black
red +
_
CONNECTING PS-85 DC POWER SUPPLY
1 2 3 4 8 7 6 5 9 10 11 12 13
1 2 3 4 8 7 6 5 9 10 11 12 13
PS-85
Connect to an AC outlet
using the supplied AC cable.
DC power cable
DC power
socket
to DC power
socket
DC power supply AC outlet
AC cable
20 A fuses
Supplied
DC power cable
13.8 V 25 A
Black
_
Red
+
NEVER connect
to
a 24 V battery.
NEVER connect
to a battery without supplied DC fuses,
otherwise the fire hazard may occur.