IBM THINKVISIONTM L170 - Manual (Page 8)

6
Connecting your Monitor
Be sure to read the 'Safety'
Information located in the
Monitor Safety and Warranty
Information Manual before
carrying out this procedure.
1. Turn off your computer and all attached devices.
2. Connect the signal cable to the video port on the back of your computer.
This port might be directly attached to your computer (figure A), or it
might be part of a video adapter card (figure B). The video port on your
computer or video adapter card might be blue to match the blue
connector on your monitor’s video cable.
* If the power cord supplied is not attached to the monitor, please follow
the instruction below:
a. Tilt monitor all the way forward.
b. Hold the top of the cable cover (a) and pull it off.
c. Gently slide the stand cover (b) backwards off the stand.
d. Connect the power cord to the power port on the back of your monitor.
e. Replace the rear covers.
3. Insert the plug into a properly grounded electrical outlet.
L170_E.fm Page 6 Tuesday, February 11, 2003 12:51 AM