IBM 71P7285 - Manual (Page 18)

Using the DVD-RAM Read function
This section contains information on using the DVD-ROM drive with
DVD-RAM discs.
Using single-and double-sided DVD-RAM media
DVD-RAM media is available in single-sided and double-sided versions.
Versions with 2.6 GB and 4.7 GB are available in Type I or Type II cartridges.
The 5.2 GB and 9.4 GB versions are double-sided and only available in Type I
cartridges.
Removing the disc from the cartridge
DVD-RAM Type II discs may be removed from the cartridge for use in
DVD-ROM drives, with DVD-RAM Read capabilities. To access the data on
both sides of the media, you must remove the disc from the drive, turn it over,
and re-insert it into the drive, for convenience, double-sided media are labeled
side A and side B. DVD-RAM Type I discs cannot be removed from the
cartridge and cannot be read by this drive.
Removing the disc from the Type II cartridge
Using the tip of a ball point pen, push and break the lock pin tab
1 . To
remove the disc, use a ball point pen to push down on the cartridge lid lock
2 and pull the cartridge lid 3 out to eject the disc. With the cartridge lid
open the disc will eject. Do not touch the recording side of the disc when
handling the bare media
.
1-10 IBM 16X Max RAM-Read DVD-ROM Drive: User’s Guide