iHome ZN14 - Manual (Page 7)

ZN10_14 IB_060807.fh10 2/12/08 10:12 AM Page 7
5
Unit does not respond AC adaptor isn’t plugged into a wall outlet or
the connector is not plugged into the power
supply jack on the back of the unit
Plug the AC adaptor into a wall outlet and plug the connector into
the supply jack on the unit. Turn Volume knob to turn unit on.
Wall outlet is not functioning Plug another device into the same wall outlet to confirm the outlet
is working. If the outlet is controlled by a switch, turn switch on.
Using no or wrong Zune insert Make sure the dock insert is the proper fit to your Zune
Zune is playing but
there’s no sound
Zune isn’t installed properly
Zune is not installed properly Remove your Zune from the dock and check for obstruction on
the connectors in the dock and on your Zune. Then reseat it in
the dock.
Function knob is not set to Zune
Zune is locked up Please make sure your Zune is working properly before docking
into the unit. Please refer to your Zune manual for details.
Zune is not installed properly
5
Troubleshooting
Solution Symptom Possible Problem
Sound source is distorted
If Zune original sound source is poor quality, distortion and noise
are easily noticed with high-power speakers.
Try a different audio source such as a music CD.
Zune is locked up/frozen
Zune battery has problem
Decrease the unit volume and set EXB switch to off Sound is distorted Volume level is set too high
Zune cannot dock
properly
Remove your Zune from the dock and check for obstruction on the
connectors in the dock and on your Zune. Then reseat it in the dock.
Zune didn’t charge
Remove your Zune from the dock and check for obstruction on
the connectors in the dock and on your Zune. Then reseat it in
the dock.
Please make sure your Zune is working properly before docking
into the unit. Please refer to your Zune manual for details.
No AM radio sound
OR very noisy
AM radio sound AM loop antenna is not connected to the
unit OR is not properly located Plug the AM loop antenna connector to the jack on the back of
the unit. Move the loop antenna away from the unit. Rotate
antenna for best reception.
Make sure Function knob is set to Zune