IOGear Wireless USB Hub GUWH104 - Manual (Page 24)

24 25
I. Compatibility with IOGEAR GUWH104KIT
Important: To retain the functionality of both the Wireless USB Host Adapter (GUWA200) and the
GUWH104KIT, you MUST follow these steps:
Uninstall the GUWH104KIT software by using Add/Remove Programs or Programs and Features on 1.
the Control Panel. Please select and remove “Ultrasuite with WiCenter Basic”. The Wireless USB Host
Adapter (GUWA200) installer will not allow you to proceed until this software is removed.
Complete the installation of the Wireless USB Host Adapter as shown in the Software Installation section.
2.
Install the GUWH104 software “Driver Hub Only” for your Wireless USB Hub from IOGEAR website. 3.
Please make sure that you are in the correct product page http://www.iogear.com/support/dm/driver/
GUWH104#display.
Use the Wireless USB Host Adapter (GUWA200) to communicate with your Wireless USB Hub
4.
(GUWH104).
Note: After this upgrade, the Wireless USB Host Adapter (GUWA100U) will not function with
the Wireless USB device or the Wireless USB Hub (GUWH104) on the PC system where the
GUWA200 software has been installed. However you may use this Wireless USB Host Adapter
(GUWA100U) on a different PC.
For more support information, please contact IOGEAR.
Appendix