Image IMTL39105.1 - Manual (Page 9)

9
10. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking
belt (see page 18). To protect the floor or carpet, place a mat under the treadmill.
8. Lower the Uprights (9, 61) until the handrails are touch-
ing the floor.
See the lower drawing. Position the Uprights (9, 61) so
that the treadmill Frame (86) is centered between them.
See the upper drawing. Firmly tighten the four 3” Bolts
(37). Then, raise the Uprights (9, 61) back to the vertical
position.
9. Attach the Storage Latch (29) and the Latch Spacer (44)
to the Left Upright (61) with two 3/4” Screws (2) as shown.
Do not overtighten the Screws.
2
61
29
44
2
42
36
34
47
7. Cover the Upright Wire (42) with the Right Grip Plate
(36). Be careful not to pinch the Upright Wire. Tighten
three 3/4” Screws (2) into the Right Grip Plate and the
Console Base.
Attach the Left Grip Plate (34) over the ground wire and
the other wires with three 3/4” Screws (2).
Be careful
not to pinch any of the wires.
2
7
9
Ground
Wire
61
9, 61
Handrail
86
9
Top View
8
37