beautypg.com

Image IMTL39105.1 User Manual

Page 7

background image

7

3. With the help of a second person, carefully tip the tread-

mill back to the upright position.

Identify the Right Handrail (72), which has a large hole in
the left side. Feed the Upright Wire (42) into the hole in
the bottom of the Right Handrail and out of the large hole
in the side. Note: It may be helpful to use needlenose pli-
ers to pull the Upright Wire out of the hole.

Attach the upper end of the Right Handrail (72) to the
Right Upright (9) with a 3” Bolt (37);

do not tighten the

Bolt yet. Attach the lower end of the Right Handrail with
a 4” Bolt (5) and a 5/16” Star Washer (80).

Then,

tighten the 3” Bolt and the 4” Bolt.

Attach the Left Handrail (71) in the same way. Note:
There is not a wire harness on the left side.

42

Hole

72

80

80

5

37

37

71

9

61

5

Hole

3

2. Identify the Right Upright (9) and the Left Upright (61).

Straighten the Upright Wire (42), and feed it into the lower
end of the Right Upright (9) and out of the upper end.
Next, hold the Right Upright against the right side of the
Base (69);

make sure that the Right Upright is turned

so that the upper end is angled in the direction
shown.
Hand tighten two 3” Bolts (37) with two 5/16” Star
Washers (80) into the Base and the Right Upright;

be

careful not to damage the Upright Wire. Do not
tighten the Bolts yet.

With the help of a second person, carefully tip the tread-
mill onto its other side. Attach the other Wheel (not
shown) as described in step 1, and then attach the Left
Upright (61) as described above.

Make sure that the

two small holes in the Left Upright are in the posi-
tion shown.
Note: There is not an upright wire on the
left side.

42

69

2

9

61

Small

Holes

37

80