beautypg.com

Connecting components, Connecting the power cord, Connecting – Integra DTR-7.7 User Manual

Page 36: Connecting your components —continued

background image

36

Connecting Your Components—Continued

With

(Remote Interactive), you can use the following special functions:

Auto Power On/Standby

When you start playback on a component connected via

, if the AV receiver is on Standby, it will automatically turn

on and select that component as the input source. Similarly, when the AV receiver is set to Standby, all components
connected via

will also go on Standby. This function will not work with components connected to an AC OUTLET

on the AV receiver.

Direct Change

When playback is started on a component connected via

, the AV receiver automatically selects that component as

the input source. If your DVD player is connected to the AV receiver’s multichannel DVD input, you’ll need to press
the [Multi CH] button to hear all channels (page 53), as the Direct Change

function only selects the FRONT jacks.

Remote Control

You can use the AV receiver’s remote controller to control your other

-capable Integra/Onkyo components, pointing

the remote controller at the AV receiver’s remote control sensor instead of the component. You must enter the appropri-
ate remote control code first (see page 85).

Notes:

• Use only

cables for

connections.

cables are supplied with Integra/Onkyo players
(DVD, CD, etc.).

• Some components have two

jacks. You can

connect either one to the AV receiver. The other
jack is for connecting additional

-capable

components.

• Connect only Integra/Onkyo components to

jacks. Connecting other manufacturer’s compo-
nents may cause a malfunction.

• Some components may not support all

func-

tions. Refer to the manuals supplied with your
other Integra/Onkyo components.

Notes:
• Before connecting the power cord, connect all of your

speakers and AV components.

• Turning on the AV receiver may cause a momentary

power surge that might interfere with other electrical
equipment on the same circuit. If this is a problem,
plug the AV receiver into a different branch circuit.

• Do not use a power cord other than the one supplied

with the AV receiver. The supplied power cord is
designed exclusively for use with the AV receiver and
should not be used with any other equipment.

• Never disconnect the power cord from the AV receiver

while the other end is still plugged into a wall outlet.
Doing so may cause an electric shock. Always discon-
nect the power cord from the wall outlet first, and then
the AV receiver.

Connecting

Components

Step 1: Make sure that each Integra/Onkyo component is connected to the AV receiver with an analog audio cable

(RCA).

Step 2: Make the

connection.

Step 3: If you’re using an MD, CDR, or HDD component, change the Input Display (see page 44).

L

R

FRONT

DVD

L

R

IN

CD

L

R

REMOTE

CONTROL

ANALOG

AUDIO OUT

L

R

ANALOG

AUDIO OUT

e.g., CD player

e.g., DVD player

Connecting the Power Cord

1

Connect the supplied power cord
to the AV receiver’s AC INLET.

2

Plug the power cord into an AC
wall outlet.
The Standby indicator lights up.