IOGear HomePlug to Ethernet Bridge GHPB42 - Manual (Page 9)

10
Installation
There are several ways to network your computers using the HomePlug Bridge. Before we get started, please
NOTE:
Do not place HomePlug devices under direct sunlight or near high heat emitting devices;
Do not place HomePlug devices near water or wet surfaces to avoid electric hazards;
Do not place HomePlug devices on any moving or unstable surfaces;
It is recommended that you plug the HomePlug devices directly into the wall outlets, not to any power adapters,
surge protectors or any device that fi lters signals.
Hardware Installation
1. Remove the HomePlug Bridge, the CAT5 cable and the installation CD from the package.
2. Allocate a space for the adapter’s placement. Make sure you avoid the places mentioned above.
3. Plug one end of the CAT5 cable into the Ethernet port on the computer, and the other end into the
Ethernet port of the bridge.
4. Plug the HomePlug bridge on the wall outlet.