iHome ZN9 - Manual (Page 5)

ZN9 IB_0521_b.fh10 6/11/08 1:24 PM Page 5
3
Using the ZN9
Connect ZN9 to Power Source
Plug the AC adaptor cable into the AC Adaptor Jack and the other end into a standard 100-240 VAC wall socket. Adaptor must be
plugged in to operate. The ZN9 does not operate on batteries.
Setting the Clock
a) To adjust the time for Daylight Saving Time, slide the DST switch to +1 to advance the time 1 hour.
Slide to -1 to turn the clock back 1 hour.
b) Press and hold the Time Zone Button until the display flashes.
c) Turn the Set Wheel to select your time zone.
d) Press the Time Zone Button again. The clock will display the current time in your time zone.
To Set Clock Manually
a) Press and hold the Clock Adjust Button. The clock display will flash.
b) Turn the Set Wheel until the current time is displayed.
c) Press the Clock Adjust Button to accept the time. The year display will flash.
d) Turn the Set Wheel to adjust the year and press the Clock Adjust Button. The date display will flash.
e) Turn the Set Wheel to adjust the date and press the Clock Adjust Button. Two beeps will indicate clock setting is complete. Use
DST switch to adjust for Daylight Saving Time.
Using the Alarms
The ZN9 has two independent alarms. Each can be set to wake you to Zune, radio or buzzer at separate times.
Setting the Alarms
a) Press and hold the or Button until the alarm time flashes.
b) Turn the Set Wheel to set the alarm time.
c) Press the or Button again and turn the Set Wheel to select having the alarm come on all week (7 days), only weekdays (5
days) or just weekends (2 days).
d) Press the or Button again and then turn the Set Wheel to select a wake source: Buzzer, Zune (last song selected) or Radio (last
selected station).
Note: If wake to source is set to Zune and Zune is not present or is not set to play song mode, the ZN9 defaults to buzzer alarm.
Arming and Disarming Alarm (Turn Alarm Function ON and OFF)
a) Press an or Button to preview current alarm time(s). Press again to arm or disarm alarm function. When armed, the related
alarm icon appears in the display.
Resetting the Alarm to Come on the Next Day
a) When the alarm is sounding, press the Button to stop the alarm and reset it to come on the following day.
Snooze
a) Press the Snooze/Dimmer Button after the alarm sounds. The alarm will be silenced and come on again after the selected snooze
time. Snooze can be pressed several times during the 2 hours alarm cycle.
b) To adjust the snooze time, during normal mode press and hold the Snooze/Dimmer Button until the display flashes. Use the
Set Wheel to adjust snooze time from 1 to 29 minutes.
Sure Alarm
The ZN9 has a sure alarm feature so the buzzer alarm will still sound in the event of power failure, if backup batteries are installed.
Zune
Playing and charging your Zune
a) Place proper insert for your Zune (see insert table under Quick Start) in Dock (slide the Zune connector to left or right to match
the proper insert if needed), then gently dock Zune. When docked, your Zune will charge until fully charged. Unit will not overcharge
Zune.
b) Press the Button to play Zune, and again to pause.
c) Turn the Volume Wheel to adjust ZN9 volume up or down.
d) Press the EQ Button to select Treble, Bass, 3D sound effect or Balance. Turn the Set Wheel to adjust settings. EQ settings for
Zune and radio mode are independent.
e) Press the Button to turn ZN9 off and pause the Zune.