Image IMTL515041 - Manual (Page 8)

8
93
82
93
109
107
21
69
108
106
106
54
6. With the help of another person, hold the console as-
sembly near the Right Upright (82) and the Left Upright
(not shown).
Connect the Wire Harness (83) to the wire harness in
the console assembly.
Make sure to connect the con-
nectors properly (see the inset drawing); the con-
nectors should slide together easily and snap into
place. If the connectors do not slide together easily and
snap into place, turn one connector and try to connect
them again.
IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON. Insert the
wire harnesses down into the Right Upright (82).
Set the console assembly on the Right Upright (82) and
the Left Upright (not shown). Thread two 1” Bolts (71)
with 1/4” Star Washers (92) into each side of the console
assembly.
After you have started all four Bolts,
tighten them.
82
Console
Assembly
83
92
71
83
7. With the help of another person, lower the console as-
sembly (not shown) to the floor. Have the other person
hold the treadmill steady during this step.
Insert the two Wheels (108) into the Wheel Housings
(106). Insert the Wheel Housings and the Wheels into
the Base (109) as shown. (Note: It may be helpful to use
a rubber mallet to fully insert the Wheel Housings.)
Open
part bag C. Attach each Wheel Housing to the Base
with a Wheel Bolt (107) and a Wheel Nut (21) as shown.
Do not overtighten the Wheel Bolts.
Center the Frame (54) between the Uprights (69, 82).
Tighten the four 5/16” x 3 1/2” Bolts (93). Then, raise the
Uprights back to the vertical position.
6
5. Attach the Console Back (95) to the console assembly
with five 3/4” Screws (6).
95
6
Console Assembly
6
6
5
7
108