Step four – Infinity TOTAL SPEAKER SOLUTIONS TSS-STAND4000 User Manual
Page 3
Step Four
Tighten the bolts on the bottom as shown. It’s recommended that
two people perform this step so that the speaker is supported
while it’s on its side and the bolts are being tightened. Attach
speaker wire as described in TSS-SAT4000 Owner’s Manual.
Bolts
25"
47-1/2"
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 3
See also other documents in the category Infinity Microphones:
- ALPHA 1200S (12 pages)
- BU-120 (16 pages)
- PS210 (19 pages)
- TSS-SUB4000 (5 pages)
- TSS-SUB4000 (32 pages)
- HPS-1.5 (8 pages)
- CS 3009 (1 page)
- 4.1t (7 pages)
- CS 60R (8 pages)
- PRIMUS P162 (8 pages)
- Sterling Series SS 2001 (1 page)
- CSW-10 (24 pages)
- 1.2s (28 pages)
- 1211w (4 pages)
- RS-125 (1 page)
- C205 (8 pages)
- Bass Link (56 pages)
- 10" Dual Voice-Coil Subwoofer Beta Ten.dvc (2 pages)
- PS210W (8 pages)
- CC-2 (10 pages)
- PS28 (6 pages)
- 10.1t Tweeter Kappa Series (3 pages)
- OVTR 2 (15 pages)
- TSS-SAT4000 (1 page)
- TSS-SAT500 (8 pages)
- TOTAL SOLUTIONS TSS-SAT800 (8 pages)
- IL100s (12 pages)
- BETA SW-12 (9 pages)
- 3-Way Full Rang Floorstanding Speakers OVTR 3 (15 pages)
- HPS-500 (16 pages)
- REFERENCE STANDARD RS 1 (8 pages)
- CAS 3.1 (12 pages)
- CLASSIA PSW310W (24 pages)
- CASCADE FIFTEEN (24 pages)
- nF4X (13 pages)
- RS KAPPA PS-8 (8 pages)
- HPS-250 (16 pages)
- Reference 1240w 12" (2 pages)
- Beta Ten 10" Subwoofer (2 pages)
- Kappa 10926 (22 pages)
- DPF-8000 (25 pages)
- Kappa 10.5t (8 pages)
- Kappa 100.3se (2 pages)
- BU-1 (16 pages)