Infinity TOTAL SPEAKER SOLUTIONS TSS-STAND4000 User Manual
Page 2
Satellite Speaker
Infinity Logo
End Cap
1/4-20 x 3/4" Screw
Installing the TSS-SAT4000
Step One
Remove the bottom end cap of the speaker by unscrewing the
single center screw (Allen wrench included with satellite).
Step Three
Align and insert the alignment pin into the bottom of the speaker.
Step Two
Attach alignment pin to stand, and run speaker wire up stand.
NOTE:
Needle-nose pliers may be required.
Alignment Pin
NOTE:
The bottom is the side
closest to the Infinity logo on
the front grille.
Alignment Pin
INFP1596Stand4000-OM 10/18/04 2:51 PM Page 2
See also other documents in the category Infinity Microphones:
- ALPHA 1200S (12 pages)
- BU-120 (16 pages)
- PS210 (19 pages)
- TSS-SUB4000 (5 pages)
- TSS-SUB4000 (32 pages)
- HPS-1.5 (8 pages)
- CS 3009 (1 page)
- 4.1t (7 pages)
- CS 60R (8 pages)
- PRIMUS P162 (8 pages)
- Sterling Series SS 2001 (1 page)
- CSW-10 (24 pages)
- 1.2s (28 pages)
- 1211w (4 pages)
- RS-125 (1 page)
- C205 (8 pages)
- Bass Link (56 pages)
- 10" Dual Voice-Coil Subwoofer Beta Ten.dvc (2 pages)
- PS210W (8 pages)
- CC-2 (10 pages)
- PS28 (6 pages)
- 10.1t Tweeter Kappa Series (3 pages)
- OVTR 2 (15 pages)
- TSS-SAT4000 (1 page)
- TSS-SAT500 (8 pages)
- TOTAL SOLUTIONS TSS-SAT800 (8 pages)
- IL100s (12 pages)
- BETA SW-12 (9 pages)
- 3-Way Full Rang Floorstanding Speakers OVTR 3 (15 pages)
- HPS-500 (16 pages)
- REFERENCE STANDARD RS 1 (8 pages)
- CAS 3.1 (12 pages)
- CLASSIA PSW310W (24 pages)
- CASCADE FIFTEEN (24 pages)
- nF4X (13 pages)
- RS KAPPA PS-8 (8 pages)
- HPS-250 (16 pages)
- Reference 1240w 12" (2 pages)
- Beta Ten 10" Subwoofer (2 pages)
- Kappa 10926 (22 pages)
- DPF-8000 (25 pages)
- Kappa 10.5t (8 pages)
- Kappa 100.3se (2 pages)
- BU-1 (16 pages)