Assembly – Image IMEL2105.1 User Manual
Page 5
5
To hire an authorized service technician to assemble the elliptical exerciser, call toll-free 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires a phillips screwdriver , two adjustable wrenches , and a rubber
mallet .
See the drawings below to identify the small parts needed for assembly. The number in parenthesis below
each drawing is the key number of the part, from the PART LIST on page 18. The number following the key
number is the quantity needed for assembly.
Note: Some small parts may have been pre-assembled. If a
part is not found in the parts bag, check to see if it has been pre-assembled.
M10 x 105mm Carriage Bolt (34)–2
M8 x 25mm Button
Screw (57)–3
M8 x 19mm Button
Screw (22)–4
M8 Nylon
Locknut (46)–4
M8 Split
Washer (74)–7
M8 Large
Washer (17)–4
M10 Split
Washer (67)–8
M10 Nylon
Locknut (29)–2
M10 x 22mm Button
Screw (21)–4
M4 x 16mm
Screw (66)–4
M4 x 19mm
Screw (39)–2
M10 x 58mm Button Screw (19)–4
Bolt Set (27)–2
M8 x 42mm Button
Bolt (50)–4
M8 x 46mm Button
Screw (20)–4
Wave Washer
(85)–2
Small Wave
Washer (90)–2
M5 x 15mm
Screw (89)–1
ASSEMBLY