Invacare 6907A - Manual (Page 2)

MPR Recline Mechanism Kit 2 Part No. 1123851
4. Remove the side panel. Refer to REPLACING THE SIDE PANEL in the Owner’s
Manual, part number 54000M107
5. Carefully tip recliner onto opposite side of recline mechanism to be replaced. Be
sure there are no obstructions on or around the floor before doing this.
6. Remove one (1) 1/4-20 x 3/4-inch pan head screw that secures the support tube to
recline mechanism.
7. Remove two (2) 1/4-20 x 1-inch hex head screws that secure the footrest cushion to
recline mechanism.
8. Remove two (2) 1/4-20 x 1/2-inch flange head screws that secure the center footrest
cushion to recline mechanism.
9. Remove four (4) bolts A, B, C and D that secure recline mechanism guard and the
recline mechanism to the seat frame.
NOTE: Ensure that the seat mounting bracket is secured by BOLT B during reinstallation.
10. Remove two (2) 1/4-20 x 1-1/2-inch hex head screws and 1/4-20 locknuts that secure
the recline mechanism to the base frame.
NOTE: Carefully support the recline mechanism while removing the last two (2) screws.
11. Position NEW recline mechanism, aligning mounting holes with holes in base frame
and seat frame.
12. Reassemble by reversing STEPS 4-10.
13. Place recliner in the upright position.
14. Repeat STEPS 4-13 to replace remaining recline mechanism.
15. Close the footrest.
16. Reinstall tray into the recliner frame.
FIGURE 1- REPLACING RECLINE MECHANISM
Seat
Frame
Base
Frame
Recline
Mechanism
1/4-20 x 1/2-inch
Flange Head
Screw
Footrest
Cushion
Center
Footrest
Cushion Seat
Cushion
Bolt A
1/4-20 x 1-1/2-inch
Hex Head Screw
and 1/4-20 Locknut
Recline
Mechanism
Guard
Support
Tube
1/4-20 x 3/4-inch
Pan Head Screw
Bolt B
Bolt C
Bolt D
Seat Mounting
Bracket
1/4-20 x 1-inch
Hex Head Screw