Image IMBE39401 User Manual
Page 9
9
10
10. Locate the High Cable (84), which is slightly longer
than the Low Cable (not shown), and notice that
there is a ball on one end of the Cable and a metal
sleeve on the other end.
Route the metal-sleeve end of the High Cable (84)
up under the lat bar rest on the Weight Guide
Frame (14), down through the indicated hole, back
up through the next hole, and then down between
the Weight Guides (9) as shown.
11. Insert the end of the High Cable (84) into the hole
in the center of the Weight Carriage (15). Attach the
Cable using a M10 x 66mm Bolt (35), two M10
Washers (37), two 24mm Spacers (38), and an M10
Nylon Locknut (29).
12 Lift the High Cable (84) in the location shown.
Attach two Pulleys (24) inside the bracket on the
Weight Guide Frame (14) using two M10 x 50mm
Bolts (86) and two M10 Nylon Locknuts (29).
84
11
15
12
29
86
24
84
14
35
37
37
29
9
14
Lat Bar
Rest
84
38
38
13
84
14
34
29
37
85
24
13. Lift the High Cable (84) in the location shown.
Attach two Pulleys (24) inside the Weight Guide
Frame (14) using two M10 x 72mm Bolts (34), four
M10 Washers (37), four 18mm Spacers (85), and
two M10 Nylon Locknuts (29).
37
37
37
85
85
85