beautypg.com

Image IMBE39401 User Manual

Page 10

background image

10

24

2

29

15

29

17

17

32

24

23

84

25

23

14. Pull the High Cable (84) down in the indicated loca-

tion, so there is no slack at the ends of the Cable.

Locate the Low Cable (25), which has two balls on
one end. Insert the metal-sleeve end of the Cable
into the indicated hole in the Weight Guide Base
(4). Attach the Cable using an M10 x 72mm Bolt
(34), two M10 Washers (37), two 28mm Spacers
(40), and a M10 Nylon Locknut (29).

Route the ball-end of the Low Cable (25) through
the bracket on the Center Base (2). Attach a Pulley
(24) inside the bracket using a M10 x 45mm Bolt
(32) and a M10 Nylon Locknut (29).

15. Wrap the High Cable (84) around a Pulley (24) as

shown. Attach the Pulley and a Cable Trap (23) to
the two Pulley Plates (17) using a M10 x 45mm Bolt
(32) and a M10 Nylon Locknut (29).

Wrap the Low Cable (25) around a Pulley (24) as
shown. Attach the Pulley and a Cable Trap (23) to
the Pulley Plates (17) using a M10 x 45mm Bolt
(32) and a M10 Nylon Locknut (29).

Make sure the Bolts (32) are inserted through
the highest and lowest holes in the Pulley Plates
(17), and that the Cables (25, 84) are between
the Cable Traps (23) and the Pulleys (24).

32

34

37

37

40

4

40

25

84

14

16

45

47

47

16. Wet the ends of the Lat Bar (45) with a small

amount of lubricant. Slide the Handgrips (47) onto
the ends of the Lat Bar.

Make sure that all parts of the weight rack are
properly tightened. In addition, pull each cable a
few times to make sure the cables move
smoothly over the pulleys. If the cables do not
move smoothly, locate and correct the problem.
When weights are used, the cables may be dam-
aged if they are incorrectly routed.