iHome AIRPLAY IW1 - Manual (Page 6)

To power the iW1 speaker ON:
1. Plug AC adaptor into Charging Base , and plug into a live AC wall outlet.
2. Place the iW1 Speaker on top of the Charging Base .
3. Slide the Master Power Switch to the ON position (on rear panel).
Note: Allow 30 seconds for the speaker to startup before interacting with the iW1 speaker.
4. Press the Power button to switch between power ON and Standby mode.
The iW1 speaker will power ON to the last state.
6 English
Getting Started
Master Power Switch
The iW1 has a master power switch that is used to power the unit ON or OFF, help conserve battery life, and reset the iW1 speaker. In order
for the iW1 speaker to power ON, the battery must be charged or unit must be connected to a AC outlet.
Master Power ON - Slide the Master Power Switch to the ON position (on rear panel) to activate your iW1 speaker.
Master Power OFF - Slide the Master Power Switch to the OFF position to power the iW1 speaker OFF.
Note: If the iW1 is in the Master Power OFF state the iW1 will only allow charging of the iW1’s internal battery and will not support
iPod/iPhone charging, remote control commands, AirPlay, network setup, nor Firmware Updates.
Powering your iW1 speaker ON
off | on
power
12V
outlet
aux-in battery
off | on
iPod dock power reset network setup status
battery
off | on
power
1 2 3
30s for startup
The iW1 speaker has an internal rechargeable battery and supports audio playback any where in the home when the battery is charged or
docked on it’s charging base with an AC adaptor.
To Charge the Battery:
1. Plug AC adaptor into Charging Base , and plug into a live AC wall outlet.
2. Dock iW1 Speaker on top of Charging Base.
Note: Allow up to 10 hours to fully charge the iW1’s battery.
To view the Battery level status:
Press the Battery Preview button to view the charge status of the iW1’s internal battery on the top volume control panel.
Rechargeable Battery
Status LED
Battery Level Preview
Current battery status level will show in place of volume level
OFF when battery is fully charged
Red, solid when battery is charging
Red, blinking when battery needs charging
aux-in battery
off | on
iPod dock power reset network setup status
battery
off | on
power