Multiquip Mikasa Vibratory Walk-Behind Roller MDR-9GH - Manual (Page 10)

PAGE 10 — MQ-MIKASA MDR-9GH VIBRATORY ROLLER — OPERATION AND PARTS MANUAL — REV. #0 (12/17/03)
MDR-9GH — RULES FOR SAFE OPERATION
■ ALWAYS refuel in a well-ventilated area, away from sparks
and open flames.
■ ALWAYS use extreme caution when working with flammable
liquids. When refueling, stop the engine and allow it to cool.
DO NOT smoke around or near the machine. Fire or
explosion could result from fuel vapors, or if fuel is spilled on
a hot engine.
■ NEVER operate the vibratory roller in an explosive
atmosphere or near combustible
materials. An explosion or fire could
result causing severe
bodily harm or
even death.
■ Topping-off to filler port is dangerous, as
it tends to spill fuel.
■ ALWAYS store the vibratory roller in a clean, dry location out
of the reach of children.
■ NEVER run engine without air cleaner. Severe engine
damage may occur.
■ NEVER leave the vibratory roller unattended, turn off engine.
■ CAUTION must always be observed while servicing this
vibratory roller. Rotating parts can cause injury if contacted.
■ DO NOT leave vibratory roller with engine running. Use
chock blocks if parking vibratory roller on a grade.
■ NEVER touch the hot exhaust manifold,
muffler or cylinder. Allow these parts to
cool before servicing engine or vibratory
roller.
■ The engine of this vibratory roller requires an adequate free
flow of cooling air. NEVER operate the vibratory roller in any
enclosed or narrow area where free flow of the air is restricted.
If the air flow is restricted it will
cause serious damage to the
vibratory roller or engine and
may cause injury to people and
property. Remember the roller’s
engine gives off DEADLY gases.
■ High Temperatures – Allow the engine to cool before adding
fuel or performing service and maintenance functions. Contact
with
hot components can cause serious burns.
CAUTION:
Failure to follow instructions in this manual
may lead to serious injury or even death! This
equipment is to be operated by trained and
qualified personnel only! This equipment is
for industrial use only.
The following safety guidelines should always be used when
operating the MIKASA MDR-9GH Vibratory Roller.
GENERAL SAFETY
■ DO NOT operate or service this equipment before
reading this entire manual.
■ This equipment should not be operated by
persons under 18 years of age.
■ NEVER operate this equipment without proper
protective clothing, shatterproof glasses, steel-
toed boots and other protective devices required
by the job. ALWAYS wear slip resistant safety
shoes or boots.
■ NEVER operate this equipment when not feeling
well due to fatigue, illness or taking medicine.
■ NEVER operate this equipment under the
influence or drugs or alcohol.
■ NEVER use accessories or attachments, which are not
recommended by Multiquip for this equipment. Damage to
the equipment and/or injury to user may result.
■ Manufacturer does not assume responsibility for any accident
due to equipment modifications.
■ Whenever necessary, replace nameplate, operation and
safety decals when they become difficult read.
■ ALWAYS wear proper respiratory (mask), hearing and eye
protection equipment when operating the vibratory roller.