Older cable box, Camcorder, Chapter 2. tv connections – MITSUBISHI ELECTRIC WD-62530 User Manual

Page 28: Figure 14. connecting an older cable box, Figure 15. analog connections for a camcorder

Chapter 2. TV Connections

Older Cable Box

Required: 3 coaxial cables, one two-way RF splitter.

These are not included with the TV.

When this setup is complete, you can use the TV remote
control, when programmed, to change channels on the
cable box.

Note: This connection is not recommended. The other

connections described in this chapter provide bet-
ter quality audio and video to the TV.

1. Connect the incoming cable to

IN on the RF splitter.

2. Connect one coaxial cable from

OUT on the RF split-

ter to

ANT 1/MAIN on the TV back panel.

3. Connect one coaxial cable from

OUT on the RF split-

ter to

IN on the standard cable box.

4. Connect one coaxial cable from

OUT on the cable

box to

ANT 2/AUX on the TV back panel.

��

��
��

��
��
��
��

��

�

��

�

��

�

��

��
��

�

��

�

��

�

��

Figure 14. Connecting an older cable box

Camcorder

Required: Analog stereo audio cables and either an S-
Video or composite video cable.
1. Connect either an S-Video or composite video cable

from

VIDEO OUT on the camcorder to VIDEO or

S-VIDEO on the TV Side Panel (Input 3). Connect
only one type of video cable; S-Video is recommended,
if available.

2. Connect left (white) and right (red) audio cables from

AUDIO OUT on the camcorder to AUDIO L and
AUDIO R on the TV Side Panel (Input 3).

��

Figure 15. Analog connections for a camcorder