MITSUBISHI ELECTRIC MCFZ-A12WV - Manual (Page 8)

8
1
2 3
4
5
AIR FLOW VELOCITY AND DIRECTION ADJUSTMENT
AIR FLOW velocity and direction can be selected as required.
■
To change the AIR FLOW velocity, press the FAN button.
Each time the button is pressed, the fan speed is changed in sequence:
(Low)
→ (Med.) → (High) → (AUTO)
• Use the (High) notch to cool/heat the room more.
• If the operating sound of the air conditioner disturbs your sleep, use the
(Low) notch.
■
To change the AIR FLOW blowing direction vertically, press the
VANE button.
Each time the button is pressed, the angle of the horizontal vane is changed in
sequence: 1
→ 2 → 3 → 4 → 5 → (SWING) → (AUTO)
SWING OPERATION
Use the swing operation for the air flow to reach all corners of the room.
Recommended horizontal vane range
Use the
(AUTO) position usually.
Use position 1 or 2 in the COOL or DRY mode and use
positions 3 to 5 in the HEAT mode when adjusting to
your requirements.
NOTE:
• In the cooling operation, when the air conditioner is operated with setting the horizontal vane to 4 or 5 for 1 hour, the
AIR FLOW direction is automatically set to horizontal to prevent condensed water from dropping.
• Adjust the vertical AIR FLOW direction using the remote controller. If the horizontal vane is moved manually, it may
cause trouble.
• In the heating operation, if the air flow temperature is too low or when defrosting is being done, the horizontal vane
position is set to position 1.
ON/OFF
FAN
TOO WARM TOO COOL
VANE
MODE
ECONO COOL
STOP
START
HR.
MIN.
AM PM CLOCK
˚C
AMPM
I FEEL
COOL DRY
AUTO HEAT
RESET CLOCK
1 2345
■
To change the horizontal direction of the AIR FLOW
For the ceiling suspended unit
•
Change the direction of the vertical vane manually.
For the floor standing unit
•
Change the direction of the vertical vane manually.
Adjust the vane before operation starts.
Since the horizontal vane moves automatically, your fingers may be caught.
• When the air flow temperature
is too low, the air is blown out
horizontally. • When the air flow temperature
rises, the air is blown out down-
wards.
AUTO AIR FLOW DIRECTION CONTROL OPERATION
When the AUTO mode is selected with the VANE button, the position of the horizontal vane is automatically set to corre-
spond to the operation mode for effective operation.
For the floor standing unit
(1) COOL, DRY (2) HEAT
For the ceiling suspended unit
(1) COOL, DRY (2) HEAT
• The air is blown out horizontally.
• The air is blown out upwards. • When the air flow temperature
rises, the air is blown out hori-
zontally. • When the air flow temperature is
too low, the air is blown out up-
wards.
COOL DR Y
HEA T
NOTE:
• When the operation mode changes in “
(AUTO)” mode, the horizontal vane is automatically changed to the
position in each mode.