Updating the firmware, Resetting the unit – Memorex MMP3774 User Manual

Page 37

WARNING! Do not update the firmware unless you are experiencing problems with

your digital audio device. Incorrect or faulty firmware installation will cause the player

to stop functioning.

1. Download the updated firmware at www.memorexelectronics.com.

2. Unzip the file, then double click setup.exe in the Desktop folder to install the

software to your computer.

3. Connect the player to the computer using the supplied USB cable and the

installation screen will appear. (If the installation screen does not appear, unplug

the USB cable and turn off the unit. Connect to the computer again and press and

hold the Power On/Off/Stop button until the installation screen appears.)

4. Follow the on-screen instructions to install the driver.

5. When finished, click START and locate the newly installed software “Beam

Cadillac” and select “Firmware Download”.

UPDATING THE FIRMWARE

To reset the unit, remove the battery for a few seconds and then replace it. This will

reset the unit but all the default settings (i.e. Radio Presets, Play mode, Equalizer,

Contrast, Power Savings, etc.) will be saved in the unit.

RESETTING THE UNIT