Marshall electronic V-R261-IMD-HDSDI - Manual (Page 4)

4
Installation and Initial Setup
■ Unpacking
Carefully unpack the V-R261-IMD-HDSDI monitor and verify that the following items are included:
• V-R261-IMD-HDSDI Monitor
• V-PS24-7.5 Power Supply with 4-Pin XLR Connector
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage,
immediately contact Marshall Electronics at (800) 800-6608. If you are not located within the continental United States,
call +1 (310) 333-0606.
■ Installation
The V-R261-IMD-HDSDI monitor provides VESA standard 75 mm and 200 mm hole patterns for attachment to VESA
mounts supporting at least 15 lbs. Adequate ventilation is required when installed to prevent possible damage to the
monitor’s internal components.
The V-R261-IMD-HDSDI can be configured as a desktop monitor with an optional stand (Part No. V-ST23-32).
■ Connections, Power-On and Initial Setup
Plug the V-PS24-7.5 power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 4-pin XLR connector
to the back of the monitor. Connect the required cables for video signal input and output. (Power must be applied to the
V-R261-IMD-HDSDI for the loop-though output to be activated.) The monitor defaults to ‘ON’ when power is supplied.
Video will automatically be detected and displayed on the screen.
For IMD setup details, see IMD Configuration Submenu on page 22.
V-R261-IMD-HDSDI with optional desktop stand
(Marshall Part Number V-ST23-32)