beautypg.com

Features of your iron – Morphy Richards 40310 User Manual

Page 5

background image

This is perfectly normal as it shows that

the iron is maintaining the heat setting you

have chosen.

It is always a good idea to begin with

cool fabrics and work up to higher settings.

An iron heats up quicker than it cools

down so you’ll save time and electricity.

Features of your iron

Temperature indicator light

The indicator light shows that the iron is

warming up. When the required temperature

is reached the light will go out and will cycle

on-off during operation.

Dry ironing

You can use your iron as a dry iron only.

Make sure the steam control ⁄ is set to the

‘ ’ symbol.

Any temperature setting may be used

depending on the garment. The spray

feature may be used provided there is water

in the tank (see filling section). You do not

need to put any water in the tank when dry

ironing only.

Spray

Press the spray

button ¤ and aim the

spray of water at

stubborn creases. You

can do this whilst dry

ironing providing there

is water in the tank.

When using the water

spray it may be necessary to push the

button a few times to get the spray pump

primed.

Steam control

Fill the iron with water as described in

‘Filling’, page 4 and insert the plug into the

electrical socket.

The steam output can be switched from

off to on by sliding the steam control C. ⁄

The steam facility should only be used

on garments which are suitable for ironing

at 2 and 3 dot setting.

Shot of steam (certain models only)

Press the shot of steam button ‹ to

obtain a burst of extra

steam for ironing out

creases in heavy material

such as denim etc.

The shot of steam can

be used whilst dry ironing,

providing there is water in

the tank, and the

temperature control is set

within the steam range.

Do not use shot of steam at

temperatures below the steam range shown

on the control.

Note: For optimum steam quality, do not

operate the shot more than three times in

succession.

Variable steam (certain models only)

Fill the iron with water as described in

‘filling’, page 4 and insert the plug into the

electrical socket.

The steam output can be varied from

low to high by the sliding the variable steam

control C. When using the iron at the

bottom of the steam temperature range, the

steam output should be adjusted to the

lowest setting.

5

Steam

No steam

C

40310 Rev 2 24/8/07 15:08 Page 5