Marshall electronic V-R151P-4A - Manual (Page 4)

4 V-R151P-4A Users Guide V-R151P-4A Users Guide
2. Function Menu (Use UP/DOWN/LEFT/RIGHT buttons to select function)
AUTO Confi gure – Used for PC signals to auto fi t image to screen.
DPMS – When selected to ON, the Digital Power Management System will place the monitor into standby when there is no
input signal for 12 seconds and will automatically turn on the monitor when a signal is applied to the last selected source.
Reset – Restores the monitor to factory settings
OSD TIME-OUT – Set time in seconds (0 to 60) for OSD to drop from screen after last button push
SLEEP TIMER – Used to automatically turn monitor off after programmed delay
Language – Not Used
3. Screen Menu
(Use UP/ DOWN/ LEFT/ RIGHT buttons to select function)
YPrPb S-Video Video PC DVI
H-Position 9 9
V-Position 9 9
Frequency 9 9
V-Position – Use LEFT and RIGHT buttons to adjust horizontal position of the PC Image
H-Position – Use LEFT and RIGHT buttons to adjust wertical position of the PC Image
Frequency – Use LEFT and RIGHT buttons to adjust the pixel clock width of the PC Image
YPrPb S-Video Video PC DVI
Auto Confi gure 9 9
DPMS 9 9 9 9
Reset 9 9 9 9 9
OSD Time Out 9 9 9 9 9
Sleep Timer 9
Language
4. Source Menu
(Use UP/ DOWN/ LEFT/ RIGHT buttons to select function)
YPrPb S-Video Video PC DVI
Analog RBG (PC) 9 9 9 9 9
Composite Video 9 9 9 9 9
S-VHS Video 9 9 9 9 9
YPrPb 9 9 9 9 9
Analog RGB – Select the on screen source display to be from the HD-15 PC connector on the rear of the unit.
Composite Video – Select the on screen source display to be from the 4 BNC(Video) connectors on the rear of the unit.
S-VHS Video – Select the on screen source display to be from the 4 Pin S-Video Connector
YPrPb – Select the on screen display to be from the component 3 BNC YPrPb connectors
DVI – Select the on screen display to be from the DVI Digital Connector
5. Alternate Menu Functions
Menu is shown by holding down ALT and then pressing the MENU button. (ALT+MENU).
Function selection and cursor movement is performed with the source selection buttons.