Additional safety rules – Motorola LS1013 User Manual

Page 3

13. DON’T OVERREACH. Keep proper footing and

balance at all times.

14. MAINTAIN TOOLS WITH CARE. Keep tools sharp

and clean for best and safest performance. Fol-
low instructions for lubricating and changing
accessories.

15. DISCONNECT TOOLS before servicing; when

changing accessories such as blades, bits, cut-
ters, and the like.

16. REDUCE THE RISK OF UNINTENTIONAL START-

ING. Make sure switch is in off position before
plugging in.

17. USE RECOMMENDED ACCESSORIES. Consult

the owner’s manual for recommended accesso-
ries. The use of improper accessories may cause
risk of injury to persons.

18. NEVER STAND ON TOOL. Serious injury could

occur if the tool is tipped or if the cutting tool is
unintentionally contacted.

19. CHECK DAMAGED PARTS. Before further use of

the tool, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended
function - check for alignment of moving parts,
binding of moving parts, breakage of parts,
mounting, and any other conditions that may
affect its operation. A guard or other part that is
damaged should be properly repaired or
replaced.

20. DIRECTION OF FEED. Feed work into a blade or

cutter against the direction of rotation of the
blade or cutter only.

21. NEVER LEAVE TOOL RUNNING UNATTENDED.

TURN POWER OFF. Don’t leave tool until it
comes to a complete stop.

22. REPLACEMENT PARTS. When servicing use

only identical replacement parts.

23. POLARIZED PLUGS. To reduce the risk of elec-

tric shock, this equipment has a polarized plug
(one blade is wider than the other). This plug will
fit in a polarized outlet only one way. If the plug
does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician
to install the proper outlet. Do not change the
plug in any way.

VOLTAGE WARNING: Before connecting the tool to a
power source (receptacle, outlet, etc.) be sure the volt-
age supplied is the same as that specified on the name-
plate of the tool. A power source with voltage greater
than that specified for the tool can result in SERIOUS
INJURY to the user – as well as damage to the tool. If in
doubt, DO NOT PLUG IN THE TOOL. Using a power
source with voltage less than the nameplate rating is
harmful to the motor.

USE PROPER EXTENSION CORD. Make sure your
extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to
carry the current your product will draw. An undersized
cord will cause a drop in line voltage resulting in loss of
power and overheating. Table 1 shows the correct size to
use depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gage. The smaller
the gage number, the heavier the cord.

ADDITIONAL SAFETY RULES

USB036-2

DO NOT let comfort or familiarity with
product (gained from repeated use)
replace strict adherence to slide com-
pound saw safety rules. If you use this
tool unsafely or incorrectly, you can suf-
fer serious personal injury.

Wear eye protection.

Keep hands out of path of saw blade. Avoid con-
tact with any coasting blade. It can still cause
severe injury.

Do not operate saw without guards in place.
Check blade guard for proper closing before
each use. Do not operate saw if blade guard
does not move freely and close instantly. Never
clamp or tie the blade guard into the open posi-
tion.

Do not perform any operation freehand. The
workpiece must be secured firmly against the
turn base and guide fence with a vise during all

Table 1: Minimum gage for cord

Ampere Rating

Volts

Total length of cord in feet

120 V

25 ft.

50 ft.

100 ft.

150 ft.

More Than

Not More Than

AWG

Not Recommended