MITSUBISHI ELECTRIC HS-HD2000U - Manual (Page 55)

53
Copying a Tape from Analog to Analog
There are two basic ways to make a copy of a tape from analog to analog.
One way is to use the HS-HD2000U to record and another VCR for playback.
The other way is to use another VCR to record and use the HS-HD2000U for playback.
Regardless of which method you may choose, you will need one RCA audio cable and one S-video cable to connect the
two VCRs. You can use either a standard RCA video cable or an S-video cable. If you do not have these cables, they
are available at your local electronics dealer. The highest quality is achieved through an S-video cable.
VIDEO IN 2 L/MONO-AUDIO IN 2 -R S VIDEO IN 2
L R L R
HS-HD2000U RECORDING PLAYBACK
VIDEO IN AUDIO IN L
AUDIO IN R S-VIDEO IN
AUDIO OUT L VIDEO OUT
AUDIO OUT R S-VIDEO OUT
Use either a video cable or an S-video cable.
Do not use both.
Using the HS-HD2000U to Record from Another VCR
1 Connect the audio cable to AUDIO OUT L and R on
the playback VCR and to AUDIO IN L and R on the
HS-HD2000U. If the playback VCR is mono, use
only the AUDIO IN L on the HS-HD2000U.
2 If the playback VCR is S-VHS, connect an S-video
cable to S-VIDEO OUT on the playback VCR and to
the S-VIDEO IN on the HS-HD2000U.
If the playback VCR is standard VHS, connect a
video cable to VIDEO OUT on the playback VCR
and to the VIDEO IN on the HS-HD2000U.
3 If the playback VCR is Hi-Fi, set the audio monitor to
Stereo.
4 Use INPUT to set the HS-HD2000U to External 1
(L1) if you used the HS-HD2000U rear panel jacks,
or External 2 (L2) if you used the HS-HD2000U
front panel jacks.
5 Put a blank tape into the HS-HD2000U. If you are
recording in S-VHS, be sure to use an S-VHS tape.
Make sure that the S-VHS record or S-ET record in
the S-VHS Set-Up menu is set correctly. See page
32, Selecting Recording Format.
Make sure that the Front S-input or Rear S-input in
the S-VHS Set-Up menu is set correctly. See page
33, Selecting S-input Setting.
6 Put the tape you want to copy into the playback VCR
and find the cue point. Press STOP if the picture
starts playing.
7 On the HS-HD2000U, press REC, then PAUSE.
8 On the playback VCR, press PLAY, then PAUSE.
9 Press the PAUSE buttons on both VCRs at the same
time to begin copying the tape.
10 When finished, press STOP on both VCRs.
Editing Features