Maretron LLP FFM100 User Manual
Ffm100 fuel flow monitor user’s manual
Table of contents
Document Outline
- 1 General
- 2 Installation
- 3 Configuring the FFM100
- 3.1 Advanced Configuration
- 3.1.1 Configuring Device Instance
- 3.1.2 Configuring Channel #0 Installation Orientation
- 3.1.3 Configuring Channel #1 Installation Orientation
- 3.1.4 Configuring Channel #0 Allow Negative Flow
- 3.1.5 Configuring Channel #1 Allow Negative Flow
- 3.1.6 Configuring Differential Mode Allow Negative Flow
- 3.1.7 Configuring Installation Description
- 3.1.8 Configuring NMEA 2000 PGN Enable/Disable
- 3.1.9 Restoring Factory Default Settings
- 3.2 Configuring the Device Label
- 3.3 Configuring the Operating Mode
- 3.4 Configuring Channel #0
- 3.4.1 Enabling/Disabling Channel #0
- 3.4.2 Configuring Channel #0 Engine Instance
- 3.4.3 Configuring Channel #0 Engine Label
- 3.4.4 Configuring Channel #0 K-factor
- 3.4.5 Configuring Channel #0 Data Damping Period
- 3.4.6 Resetting the Total Volume Recorded for Channel #0
- 3.4.7 Configuring Channel #0 Temperature Instance
- 3.4.8 Configuring Channel #0 Temperature Source
- 3.4.9 Configuring Channel #0 Temperature Label
- 3.5 Configuring Channel #1
- 3.5.1 Enabling/Disabling Channel #1
- 3.5.2 Configuring Channel #1 Engine Instance
- 3.5.3 Configuring Channel #1 Engine Label
- 3.5.4 Configuring Channel #1 K-factor
- 3.5.5 Configuring Channel #1 Temperature Coefficient
- 3.5.6 Configuring Channel #1 Data Damping Period
- 3.5.7 Resetting the Total Volume Recorded for Channel #1
- 3.5.8 Configuring Channel #1 Temperature Instance
- 3.5.9 Configuring Channel #1 Temperature Source
- 3.5.10 Configuring Channel #1 Temperature Label
- 3.1 Advanced Configuration
- 4 Maintenance
- 5 Troubleshooting
- 6 Technical Specifications
- 7 Technical Support
- 8 Installation Template
- 9 Maretron (2 Year) Limited Warranty