beautypg.com

Multiquip Mikasa Reversable Plate Compator MVH-R60H User Manual

Page 15

background image

MVH-R60H —OPERATION AND PARTS MANUAL — REV. #1 (09/09/04) — PAGE 15

MVH-R60H — COMPONENTS (HONDA GX120K1SM12 ENGINE)

Figure 4. Honda GX160K1QA2 Engine Controls & Components

INITIAL SERVICING

The engine (Figure 4) must be checked for proper lubrication
and filled with fuel prior to operation. Refer to the manufacturer's
Engine manual for instructions & details of operation and
servicing.

1. Fuel Filler Cap – Remove this cap to add unleaded gasoline

to the fuel tank. Make sure cap is tightened securely. DO
NOT
over fill.

WARNING

Operating the engine without an
air filter, with a damaged air filter,
or a filter in need of replacement
will allow dirt to enter the engine,
causing rapid engine wear.

NOTE

CAUTION - Fueling The Engine

Adding fuel to the tank should be done only
when the engine is stopped and has had an
opportunity to cool down. In the event of a fuel
spill, DO NOT attempt to start the engine until
the fuel residue has been completely wiped
up, and the area surrounding the engine is dry.

2. Throttle Lever – Used to adjust engine RPM speed (lever

advanced forward SLOW, lever back toward operator
FAST).

3. Engine ON/OFF Switch – ON position permits engine

starting, OFF position stops engine operations.

4. Recoil Starter (pull rope) – Manual-starting method. Pull

the starter grip until resistance is felt, then pull briskly and
smoothly.

5. Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop

the flow of fuel.

Engine components can generate extreme heat.
To prevent burns, DO NOT touch these areas
while the engine is running or immediately after
operating. NEVER operate the engine with the
muffler removed.

CAUTION - Burn Hazard

10. Fuel Tank – Holds unleaded gasoline. For additional

information refer to engine owner's manual.

8. Spark Plug – Provides spark to the ignition system. Set

spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) for
Honda engine. Clean spark plugs once a week.

9. Muffler – Used to reduce noise and emissions.

6. Choke Lever – Used in the starting of a cold engine, or in

cold weather conditions. The choke enriches the fuel mixture.

7. Air Cleaner – Prevents dirt and other debris from entering

the fuel system. Remove wing-nut on top of air filter cannister
to gain access to filter element.

This manual is related to the following products: