Meridian America DSP8000 - Manual (Page 30)

26
Configuring
the DSP8000
loudspeakers
Specifying information about your system
You can configure the operation of the DSP
loudspeakers to suit the way your system is set up, and
the way in which you want to use it.
These settings are configured automatically to
appropriate values when you choose one of the
standard Type settings, and you should not normally
need to alter them; see
Choosing standard settings,
page 24.
To configure the DSP loudspeaker
Turn off the DSP loudspeaker, using the power
switch on the back panel.
Turn on the power again while holding down the 0
key on the remote.
The display will show the current setting of the first
configuration option.
For example:
L.M.RJ45
Press > or < to step between the options.
Press A or V to change the value of the current
option.
The following table shows the options you can
configure:
•
•
•
•
Option Initial value in Type 1
Position and master/
slave L.
Compatibility (G, 500,
200 Pre, or 200 CD)* G
Controller mode (Auto,
Con, or NCon) Auto
System address (1–8) S.A. 1
Product address (1–8) P.A. 1
Volume mode
(1=normal, 2/3=second
or additional room) L.E. 1
Balance control
(N or Y) Bal. Y
Centre menus? (N or Y) Centre N
Diagnostic displays?
(N or Y) Diag. N
* G gives 500 Comms and MSR+ sources, 500 gives
500 Comms and MSR sources, and 200 Pre or 200
CD are legacy modes.