Meridian America DSP8000 - Manual (Page 2)

ii
Preface Important safety instructions
Read the instructions.
Keep these instructions.
Follow all instructions.
Do not use this apparatus near water.
Clean only with a dry cloth.
Install only in accordance with the manufacturer’s
instructions.
Refer all servicing to approved service personnel.
Do not disassemble – no user-servicable parts inside.
This apparatus has been designed with Class 1
construction and must be connected to a mains socket
outlet with a protective earthing connection (the third
grounding pin).
The apparatus may be isolated from mains power either
by unplugging the power connector from the rear of the
unit, or by unplugging the connector at the opposing
end of the power cord or cable from its supply outlet.
As a result, either or both of these connectors should
remain accessible.
Safety warnings
WARNING: TO REDUCE THE RISK OF FIRE OR
ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
Do not expose the unit to dripping or splashing.
Do not place any object filled with liquid, such as a
vase, on the unit.
Do not place naked flame sources, such as lighted
candles, on the unit.
•
•
•
•
•
•
•
•
•
•
•
To avoid overheating
Leave at least 10cm around the equipment to ensure
sufficient ventilation.
Do not position the unit:
In direct sunlight.
Near heat sources, such as a radiator.
Directly on top of heat producing equipment.
To avoid interference
Do not position the unit:
Near strong electrical or magnetic radiation, such as
near a power amplifier.
Radio interference
FCC Warning: This equipment generates and can
radiate radio frequency energy and if not installed and
used correctly in accordance with our instructions may
cause interference to radio communications or radio
and television reception. It has been type-tested and
complies with the limits set out in Subpart J, Part 15 of
FCC rules for a Class B computing device. These limits
are intended to provide reasonable protection against
such interference in home installations.
EEC: This product has been designed and type-tested
to comply with the limits set out in EN55013 and
EN55020.
•
•
•
•
•