Miller Electric MSC-2 - Manual (Page 15)

OM-1096 Page 11
5-3. Slide Maintenance
ST-154 580
Turn OFF and unplug unit.
1 Gun Mounting Plate
2 Slide Cover With Seal
3 Shaft
4 Screw Lead
5 Pillow Block Oil Hole
Disassemble as shown. Wipe all
surfaces clean. Lubricate pillow
block with No. 20 oil. Lubricate
screw lead with No. 90 oil.
Reinstall cover and plate.
Tools Needed:
3/16 in.
1
2
3
4
5
5-4. Drive Belt Adjustment
ST-154 579
Turn OFF and unplug unit.
Remove screws and open access
door. Clean drive pulleys. Adjust
belt as follows:
1 Motor Pulley
2 Toothed Drive Belt
3 Bolt
4 Belt Housing
5 Drive Pulley
Loosen four bolts and slide belt
housing towards motor to tighten
belt. Do not overtighten belt.
Tighten bolts, and close and secure
access door.
Tools Needed:
7/16 in.
1 2 3 4 5
Motor