Mobi Technologies 70060 - Manual (Page 9)

INSTALLATION
INSTALLING BATTERIES
Camera:
1. Remove the battery cover at the bottom or back of the unit.
2. Insert four (4) 1.5 volt AA size batteries according to marking in the battery
compartment.
3. Align the battery cover tabs with the camera tab holes and replace the cover.
Monitor:
1. Remove the battery cover at the back of the unit.
2. Insert six (6) 1.5 volt AA size batteries according to the marking of the battery
compartment.
3. Align the battery cover tabs with the monitor tab holes and replace the cover.
PLEASE NOTE:
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard or rechargeable batteries
3. Remove the batteries during long period of non-use.
INSTALLING AC/DC ADAPTOR:
1. Install the plug of AC adaptor to the DC jack of the unit.
2. Plug the AC adaptor into a standard wall AC power outlet.
3. Switch on the unit with the power ON/OFF switch.
4. The power indicator will be illuminated.
Warning: Improper use of the AC/DC adaptor may damage or cause the units to
malfunction, voiding the warranty.
Please note that the service life of batteries is limited. Therefore, when monitoring
over long periods and, in particular, overnight, it’s recommended to use AC adaptors
for both camera and monitor units.
Use only the AC/DC adaptors supplied with the MobiCam AV System.
Please remove batteries from the camera when using the AC adaptor, and make sure
only rechargeable NiMH batteries [or no batteries] are inside the battery compartment
of the monitor.
8