MITSUBISHI ELECTRIC WS-73909 - Manual (Page 78)

78 78
A
p
p
e
n
d
ix
E
:
D
ia
m
o
n
d
S
h
ie
ld
™
In
s
ta
ll
a
ti
o
n
Appendix E: Diamond Shield Instructions
Diamond Shield™ Installation
The instructions below will lead you through the
Diamond Shield installation process. Included
in the Diamond Shield package are the following
items:
For models WS-65909 and WS-73909 only.
(1) Diamond Shield™
(2) molding clips
1
Carefully remove the Diamond Shield™ from
the protective packaging. Wipe off any dust with
a lint-free cloth. Do not use any cleaners on the
anti-glare Diamond Shield™.
2
Begin by inserting the shield, sliding it into
the channels, starting at the bottom. Gently
bow the Diamond Shield™ toward you and
insert the top of the Diamond Shield™ into the
top channel.
3
Install the left and right molding clips by
pressing them into the opening, starting at a
corner. Do not force the clip. The clip will slide
into place. This completes the Diamond Shield™
installation.
To remove the Diamond Shield™,
reverse the order of the above process.
Diamond Shield™ for the model
WS-55909 comes installed by the fac-
tory.
2
3
for Models WS-55909,
WS-65909 and, WS-73909