Maytag W10117890A - Manual (Page 11)

11
Laundry tub drain or standpipe drain
Connecting the drain hose form to the corrugated drain hose
1. Feed end of drain hose into one end of form. Place end of drain hose form into the drain
hose relief.
2. Bend the hose over the top of the form and feed into the other end of the form.
If drain hose does not fit into standpipe or if placing over the edge of a laundry tub:
■ Place coupling on end of drain hose. Use a screwdriver to install hose clamp.
■ Then slide the second hose clamp onto coupling. Insert end of adapter into coupling. Use
a screwdriver to install second hose clamp over coupling.
To keep drain water from going back into the washer:
■ Do not force excess drain hose into standpipe. Hose should be secure but loose enough
to provide a gap for air.
■ Do not lay excess hose on the bottom of the laundry tub.
Floor drain
Do not install the drain hose form on to the corrugated drain hose. You may need additional
parts. See Floor drain under “Tools and Parts.”
Connect the Inlet Hoses
The washer must be connected to the water faucets using the new inlet hoses. Do not use old
hoses.
Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in
the couplings.
Connect the inlet hoses to the water faucets
Make sure the washer basket is empty.
1. Attach the hose labeled hot to the hot water faucet. Screw on coupling by hand until it is
seated on the washer.
2. Attach the hose labeled cold to the cold water faucet. Screw on coupling by hand until it
is seated on the washer.
3. Using pliers, tighten the couplings with an additional two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can
result.
A. Drain hose reliefs
A
A. Coupling
B. Washer
A B