Mercedes-Benz 2011 SL-Class - Manual (Page 276)

X Turn bulb socket = clockwise until it
engages.
Driver’s side headlamp: Cable outlet ?
of bulb socket = must point towards the
lower right.
Passenger-side headlamp: Cable
outlet ? of bulb socket = must point
towards the lower left.
X Place bulb socket ; back into the housing.
X Align housing cover : and turn it
clockwise until it engages.
Parking and standing lamp bulb
X Turn housing cover : counterclockwise
and remove it.
X Pull out bulb socket ;.
X Pull the bulb out of bulb socket ;.
X Gently press the new bulb into bulb
socket ;.
X Place bulb socket ; back into the housing.
X Align housing cover : and turn it
clockwise until it engages.
Corner-illuminating lamp bulbs
X Turn housing cover : counterclockwise
and remove it.
X Turn bulb socket A counterclockwise and
remove it.
X Pull the bulb out of bulb socket A.
X Gently press the new bulb into bulb socket
A.
X Insert bulb socket A into the guide in the
headlamp.
X Turn bulb socket A clockwise until it
engages.
The handle of the bulb socket must be
vertical.
X Align housing cover : and turn it
clockwise until it engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X Switch off the ignition.
X Turn the exterior lamp switch to position
$.
X Open the trunk.
Tail lamp unit
Opening the driver’s side trim panel
X Turn lock : counterclockwise by 90°.
X Remove cover ;.
Opening the passenger-side trim panel
X Move lock : in direction of the arrow and
remove cover ;.
274
Replacing bulbs
Practical hints
230_AKB; 6; 22, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-28T18:49:58+02:00 - Seite 274