Mercedes-Benz 2011 SL-Class - Manual (Page 123)

The Vehicle status message memory menu
only appears if messages have been stored.
G Warning!
Malfunction and warning messages are only
indicated for certain systems and are
intentionally not very detailed. The
malfunction and warning messages are
simply a reminder with respect to the
operation of certain systems. They do not
replace the owner’s and/or driver’s
responsibility to maintain the vehicle’s
operating safety. Have all required
maintenance and safety checks performed on
the vehicle. Bring the vehicle to an authorized
Mercedes-Benz Center to address the
malfunction and warning messages.
X Press button V or U repeatedly until
the
Vehicle status message memory
menu appears in the multifunction display.
If conditions have occurred causing status
messages to be recorded, the number of
messages appears in the right
multifunction display.
X Press button & or *.
The stored messages will now be displayed
in the order in which they have occurred.
For malfunction and warning messages,
see “Vehicle status messages in the
multifunction display” (
Y page 226).
i After you have scrolled through all
recorded status messages, the first
recorded message appears again.
Should the vehicle’s system record any
conditions while driving, the number of
messages will reappear in the multifunction
display when the SmartKey in the starter
switch is turned to position
0 or removed
from the starter switch. With KEYLESS-GO,
the number of messages will reappear when
you turn off the engine by pressing the
KEYLESS-GO start/stop button and open the
driver’s door.
Except for high-priority messages, the vehicle
status message memory will be cleared when
you switch off the ignition.
Settings menu
Introduction
In the Settings menu there are two
functions: The function To reset, press
reset button for 3 seconds, with which
you can reset all the settings to the original
factory settings and a collection of submenus
with which you can make individual settings
for your vehicle.
The following settings and submenus are
available in the
Settings menu:
R
Resetting to factory settings
(
Y page 121)
R Submenus in the Settings menu
(
Y page 122)
R Instrument cluster submenu
(
Y page 122)
R
Lighting submenu ( Y page 124)
R
Vehicle submenu ( Y page 126)
R
Convenience submenu ( Y page 127)
Resetting to factory settings
You can reset the settings of all submenus to
the factory settings.
For safety reasons, the function
Light
Circuit Headlamp Mode in the Lighting
submenu cannot be reset while driving.
X Press button V or U repeatedly until
the
Settings menu appears in the
multifunction display.
Control system
121
Controls in detail
230_AKB; 6; 22, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-28T18:49:58+02:00 - Seite 121
Z