Philips Magnavox CD130MW8 - Manual (Page 15)

15
EN
WATCHING TV
OPTIONAL SETTING
OPERATING DVD
INTRODUCTION
CONNECTION
INITIAL SETTING
DVD SETTING
INFORMATION
TROUBLESHOOTING
ESPAÑOL
TV Screen Display Mode
2 types of display modes can be selected in the digital mode.
DTV
1
Press [SET-UP] to display the main menu.
2
Use [Cursor K / L] to select “DTV SETUP”, then
press [ENTER].
e.g.) digital TV mode
or
--- TV SETUP ---
CHANNEL SETUP
V-CHIP SETUP
LANGUAGE [ENGLISH]
CAPTION [OFF]
DTV SETUP
3
Use [Cursor K / L] to select “DTV DISPLAY”, then
press [ENTER] repeatedly to switch the desired TV
aspect ratio.
or
--- DTV SETUP ---
DTV DISPLAY [LETTERBOX]
DTVCC
ZOOM LETTERBOX
[LETTERBOX]
Display the digital-supported program in full-screen.
Black borders will spread in the upper and lower
screen.
[ZOOM]
Enlarge and display the center area of the digital-sup-
ported program.
The right and left side of image will be cut off.
4
Press [SET-UP] to exit.
Note:
• You may not switch the display mode depending on the
program.
5 Sleep Timer
The sleep timer can be set to automatically turn off the unit after an
incremental period of time.
1
Press [PICTURE/SLEEP] repeatedly until the sleep
timer menu appears.
[SLEEP]
[BRIGHT]
[CONTRAST]
[COLOR]
[TINT]
[SHARPNESS]
SLEEP OFF
• Sleep timer menu appears on the TV screen.
2
Use [Cursor { / B] to change the amount of time
until turn off the unit.
or
SLEEP 90MIN.
• You can set the unit to turn off after a set period of
time (from 30 to 120 minutes).
• Each time you press [Cursor { / B], the amount of
time will increase or decrease by 30 minutes.
• After set up, the sleep timer menu can be called up
for checking by pressing [PICTURE/SLEEP].
To Cancel the Sleep Timer
Use [Cursor { / B] at step 2 until “OFF“ is displayed
on the TV screen.
Note:
• The sleep timer setting display will automatically disappear
in 10 seconds.
• When you turn off the unit or when a power failure occurs,
the sleep timer setting will be canceled.
5
P7401UM_CD130MW8.indd 15 2007/04/23 9:38:18