Vcr to an antenna or wall outlet cable, Chapter 2. tv connections – MITSUBISHI ELECTRIC WD-52631 User Manual

Page 28

Chapter 2. TV Connections

VCR to an Antenna or Wall Outlet
Cable

Required: Two-way RF splitter, 3 coaxial cables, right and
left analog audio cables, either S-video or video cable.

These are not included with the TV but are available at

most electronics stores.

1. Connect the incoming cable or antenna to

IN on the

RF splitter.

2. Connect one coaxial cable from

OUT on the RF split-

ter to

ANTENNA IN on the VCR back panel.

3. Connect one coaxial cable from

OUT on the RF split-

ter to

ANT 1/MAIN on the TV back panel.

4. To use the TV speakers with the VCR, connect left

(white) and right (red) audio cables from

AUDIO

OUT on the VCR to INPUT/AUDIO LEFT and

AUDIO RIGHT on the TV back panel. If your VCR is

mono (non-stereo), connect only the white (left) cable.

Figure 9. Connecting a VCR to an Antenna or Wall Outlet Cable

5. Connect either an S-Video or composite video

cable from

VIDEO OUT on the VCR back panel to

INPUT/VIDEO or S-VIDEO on the TV back panel.

Connect only one type of video cable; S-Video is

recommended, if available.

Optional

To record high-definition digital channels converted

to analog standard-definition video and analog stereo
audio, perform these two additional steps.
6. Connect left (white) and right (red) audio cables

from

AUDIO IN on the VCR to MONITOR OUT

LEFT/RIGHT on the TV back panel. If your VCR
is mono (non-stereo), connect only the white (left)

cable.

7. Connect a composite video cable from

VIDEO

IN on the VCR back panel to MONITOR OUT/
VIDEO on the TV back panel.

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

�

��

��
��

��

�

��

�

��

�

��

�

��

��
��

��

��
��
��
��

��