Safety steps, Burning solid fuels – Nesco 6033 User Manual
Page 3
USSC
3
Ashes will have to be Removed from the stove periodically. See cleaning procedure. You can minimize cleaning required
and maximize efficiency by maintaining the correct draft settings. See “Draft Setting” further in the manual.
The draft setting on your stove may have to be changed from time to time to accommodate your specific burning conditions.
Proper draft setting will be discussed later in this manual. The point we wish to make here is that your American Harvest
stove, due to the nature of solid fuels, will require brief periodic attention. Please do not expect to light your stove and walk
away from it until you want to shut if off in the spring. A few moments of adjustment and cleaning from time to time is an
important part of burning solid fuels.
The American Harvest stove has been designed to burn shelled corn, wood pellets and other pelletized fuels that meet
Association of Pellet Fuel Industries standards.
SAFETY STEPS
IMPORTANT:
Proper installation of this stove is necessary for safe and efficient operation.
Installing this product improperly may result in a house fire and personal injury. All applicable
building codes for your location must be followed. In areas where building codes require additional
steps to the installation of this product not included in this manual the building codes will take
precedent and must be followed. Contact your local building inspector to obtain any necessary
permits or inspection guidelines before installing the product.
•
•
•
•
•
•
•
•
•
•
The American Harvest stove is designed to burn shelled corn, cherry pits, or pelletized fuel
such as wood pellets. The burning of other solid fuels such as cord wood in this stove is not
permitted.
This product requires simple periodic maintenance for proper operation and long life of the
stove. Read and follow the maintenance schedule closely.
DISCONNECT THE POWER CORD BEFORE SERVICING THIS STOVE! A power surge
protector is required. The unit must be plugged in to a grounded 110-volt power source.
Always route the power cord away from the unit. Do not route cord in foot traffic areas. Do not
pinch cord under furniture.
A working smoke detector must be installed in the same room as this product.
Flammable or explosive liquids such as gasoline, naphtha or engine oil must NEVER be used in
or around this stove. These liquids must be stored well away from this stove as the open flame
in the burner chamber could ignite the fumes of such liquids. Do not burn garbage in this unit.
The moving parts of this stove are propelled by high torque electric motors. The auger and Fuel
Agitator can cause severe injury to body parts that may get near them. Keep all body parts away
from the auger and Fuel Agitator while the stove is plugged into an electrical outlet. These
moving parts may begin to move at any time while the stove is plugged in.
According to HUD requirements, when installed in a mobile home, this stove must be grounded
directly to the steel chassis of the mobile home and bolted to the floor.
This stove is not intended for use in commercial installations.
Do not connect this stove to “B” vent. Use UL Listed Pell Vent
BURNING SOLID FUELS