Makita BO6030 - Manual (Page 7)

7
NOTE:
• The figure shows standard applications. They may differ
under certain conditions.
CAUTION:
• If the tool is operated continuously at low speeds for a
long time, the motor will get overloaded, resulting in tool
malfunction.
• The speed adjusting dial can be turned only as far as 5
and back to 1. Do not force it past 5 or 1, or the speed
adjusting function may no longer work.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Front grip
Install the front grip on the tool so that its protrusions fit into
the matching notches in the front of the tool. Secure the front
grip using a screwdriver to tighten the screw through the hole
in the front grip.
Installing or removing abrasive disc
CAUTION:
• Always use hook-and-loop system abrasive discs. Never
use pressure-sensitive abrasive discs.
To install the abrasive disc, first remove all dirt or foreign
matter from the pad. Then attach the abrasive disc to the
pad, using the hook-and-loop system of the abrasive disc
and the pad. Be careful to align the holes in the abrasive disc
with those in the pad.
To remove the disc from the pad, just pull up from its edge.
1. Notches
2. Front grip
3. Hole in front grip
4. Screwdriver
4
3
2
1
003738
1. Abrasive disc
1
003739