Morphy Richards EB75310 - Manual (Page 8)

7
HOW TO USE
1 Ensure the blanket is fitted to
the bed correctly. Move the
slider switch to the ‘OFF’
position.
2 Plug the power lead into the
closest socket, using an
extension lead, if needed, to
ensure that the lead is not
stretched.
Start up
1 When plugged in, the red power
LED will illuminate. The switch is
already in time set mode.
2 Select the appropriate hour,
AM/PM, by using the down
arrow ‹ A or the up arrow ‹B.
Press the mode button fl. The
minute symbol will then flash,
select the appropriate time.
Press mode again and the clock
will be set A.
Heating the bed
1 Move the slider switch to the
‘ON’ position, the green LED ‡
will illiuminate and heat level 1 is
automatically selected.
2 Select the heat required using
the up and down arrow buttons
level 1-9 B.
NOTE: Make sure when you get
into bed that the blanket is
switched off, or reduced to a
level suitable for all night use
(1-4).
All night use
(manual)
NOTE: Blankets are perfectly
safe to be used all night.
However, we recommend using
the heat setting below.
1 Select the ‘ON’ position
2 Using the up and down buttons,
select your desired heat level
(1-4).
• This setting will provide safe
and comfortable heat to sleep
on all night.
• This setting can be used to air
the bed.
WARNING: Always ensure
that the slider switch is
moved to the OFF position
when you get up the next
day, or after airing the bed.
Boost button
At any time during use, if the
boost button fi is pressed, the
switch will increase by two heat
levels, for 30 minutes E.
Then it will revert back to the
previous heat level.
If, within this 30 minutes, the
boost button is pressed again, it
will revert to the original setting.
This feature can be used any
number of times during use.
Sleep button
1 Move the slider switch to sleep
position. The sleep symbol will
be lit up F.
2 There is no heat output from the
blanket until the boost button is
pressed. The default level is 4, it
can be altered by using the up
and down buttons to your
desired level. This will maintain
for 30 minutes then switch off
G .
If, at any time during this period,
the boost is pressed again, the
heat will be switched off.
CLOCK
7.30
PM
7.30
PM
ON
3
C
D
E
7.30
PM
ON
4
BOOST
F
7.30
PM
SLEEP
ON
G
7.30 AM
PM
SLEEP
ON
4
BOOST
75310 rev2 11/1/08 15:33 Page 8