Mark Levinson 532 - Manual (Page 10)

6
Mark Levinson
If this case occurs, consider installing a dedicated AC circuit for the
system. Contact a licensed electrician for assistance. If more than
one AC circuit is providing power to the system, contact a licensed
electrician to ensure that all components are operating with the
same solid, low-impedance ground reference.
Caution!
Building regulations and electrical codes differ from location to
location, making it impossible to anticipate the requirements of
amplifier high-current AC circuits, such as the N
o 532 dual
monaural power amplifier is capable of using. Contact a local,
licensed electrician for further information.
Operating States The Nº532 dual monaural power amplifier is designed for
continuous operation and has four operating states:
• Off – AC power is disconnected using the front-panel Power
switch or by removing the power cord from the rear panel.
• Power Save Mode – this is an energy-saving mode. AC power
is only connected to the low-voltage power supply, so all
nonaudio functions, such as ML Net and Link2, are active.
• Standby – AC power is fully connected to the amplifier but the
outputs are muted.
• On – the Nº532 is fully powered and all outputs are active.
The Nº532 should be unplugged during lightning storms and
extended periods of nonuse as a precaution against potentially
damaging power surges through the line.
Caution!
BEFORE moving the N o 532 power amplifier, make sure it is
powered off with the Power button. Then make sure the power
cord is disconnected from the rear panel connector and the
electrical outlet.