Philips Magnavox VPA115PR - Manual (Page 11)

Mobile Connections 11
When passengers in your vehicle want to watch a video program, hook up the VCP by following the steps
below.
1
Make sure your vehicle has a 13.2-volt, negative ground
electrical system. Unplug the AC power cords of the VCP
and the TV.
2
Connect one end of the car battery cord to the 13.2V Jack
on the back of the VCP.
3
Connect the other end of the car battery cord to the ciga-
rette lighter jack in your vehicle.
4
Follow step 3 on page seven to connect the VCP to a TV.
ANT OUT
ANT IN
AUDIO
CH3
CH4
VIDEO
OUTPUT 13.2V
AC Power Cord
Car Battery Cord
(supplied)
To 13.2V Jack
To Cigarette Lighter Jack
• Do not watch TV while driving.
• Use only the supplied car battery
cord. Using another cord could dam-
age the VCP or cause faulty opera-
tion.
• Make sure the cigarette lighter jack
is free of ashes and other debris.
• Make sure you push the car battery
cord’s plug completely into the ciga-
rette lighter jack.
• Always unplug the car battery cord
from the cigarette lighter jack
before you unplug it from the VCP.
• You must disconnect the car battery
cord from the VCP before you can
use standard AC electrical power.
• If the vehicle’s engine is off, there
will not be enough electrical voltage
to operate the VCP.
• Unplug the car battery cord from
the cigarette lighter jack when you
have finished using the VCP.
Helpful Hints
5
Connect the TV to a DC power source. The TV must
have an AC/DC Jack.