M&S Systems MNCXS - Manual (Page 11)

Important Safety Note: Proper selection of mounting
hardware not included herein and proper assembly and
installation of brackets, including but not limited to
selection of appropriate weight bearing support and bracket
use with the specified speaker only is the exclusive
responsibility of the customer. M&S Systems disclaims any
liability for the selection of mounting hardware and/or
proper bracket installation.
Please follow the instructions below and refer to the diagram
when mounting the MNCX mini-cube speakers to your wall or
ceiling.
1. Loosen and remove the molded nut (B) by turning it
counter clockwise. Use the supplied metal bar (E) if
necessary by inserting it in one of the holes on the
molded nut (B).
Mounting Your Speakers
Speaker Connections
To connect your new speakers to your stereo or home theater
system, please follow these instructions.
1. Turn off the receiver or amplifier and unplug it from the
power outlet.
2. Use a 2-conductor, 16-gauge speaker wire (M&S part
number MS16X) for best results.
Note: Remove about 2 inches of the outside jacket from both ends of
the wire then strip approximately ½ inch of the insulation from each
conductor at the speaker end. Use the recommended strip length as
specified in the amplifier/receiver installation manual for the other end
of the wire.
3. Proper connection of the speaker wire is very important
to ensure full range sound. Most amplifiers and speakers
use red (for +) and black (for -) as the polarity markings.
Using the MS16X wire makes connections easy. The red
wire should be connected to the red terminal and the
black wire to the black terminal at the speakers and the
amplifier.
Note: When using another type of wire, such as a flat ribbon, you will
need to determine how the wire denotes one lead from another. This
usually takes the form of a rib or a color stripe in the insulation.
4. Repeat these steps for connection of all speakers to the
system.
Page 6 MNCX/MNCXS Owners Manual M&S Systems Page 11
The MNCX unit is designed with a swivel joint between the two
speakers allowing each speaker to be individually aimed. The
unit also comes with a mounting bracket for attachment to a
wall or ceiling. The bracket screws into the threaded socket on
the back of the top speaker, and may be adjusted so that the
speakers point in the desired direction.